Carrier Access CMG Router Manual do Utilizador descarregar pdf (Página 228)

11-2 CMG Router - Release 2.7

Router Configuration

Installation

Installation of the CMG Router card into the Adit 600 chassis.

 Unit can be on or off

 CMG Router card will work in any slot

 Slide card into slot until fully seated

 CMG Router has completed it’s boot cycle when CRD light is solid

The following setups are all executed with CLI

NOTE: Configuration can be done with the following CLI commands or with

the Router Menu-Driven Software.

Basic Setup

Command Description

set {ds0-addr} type data Confirm DS0 is set to type data.

ds0-addr = {slot:port:channel} of DS0

Example: set a:1:1-24 type data

connect {slot:port:trunk}

{slot:port:channel}

Cross-connect T1 to router card.

Example: connect a:1:1-24 6:1:1 (router in slot 6)

set {router-addr} proxy Disable/enable router proxy.

router-addr = {slot:port}| of router card.

Example: set 6:1 disable.

set {slot:port} up Set Router LAN as In-Service. Example: set 6:1 up

telnet {router_card-addr} Telnet to Router card.

router_card-addr = {slot} location of router card

Example: telnet 6 (if earlier than 3.0 release {slot:port} must

be used)

Local and Remote Profile Setup

reinitialize To enable any configuration changes, the card must be

reinitialized.

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 295 296

Sem comentários

Carrier Access CMG Router Manual do Utilizador Página 228