Carrier-access Access Navigator Manual do Utilizador descarregar pdf (Página 207)

100

101

Access Navigator - Release 1.8 August 2003 9-13

Provision DCS Service

Provision “Groom” DS1 Circuits to Network

5. Set groom DS1 line code to AMI or B8ZS with the following command:

set ds1 <n> linecode <ami|b8zs>

Example: set ds1 10 linecode b8zs

6. Set groom DS1 circuit ID with the following command:

set ds1 <n> id <"id">

Example: set ds1 10 id "Acme Corp DS1#5"

The ID may contain up to 20 characters and must be enclosed in quote marks.

NOTE: DS1 clock must be set to “normal” for normal operation.

7. Set groom DS1 clock source to normal or loop with the following command:

set ds1 <n> clock <normal|loop>

Example: set ds1 10 clock normal

8. Set groom DS1 line buildout (lbo) to required DSX-1 equalization or CSU attenuation with the

following command:

set ds1 <n> lbo <setting>

Example: set ds1 10 lbo 3

The setting is a number from 1 to 9, and is defined as follows:

Setting

Definition

1 Set DSX-1 equalization for 0-133 ft.

2 Set DSX-1 equalization for 133-266 ft.

3 Set DSX-1 equalization for 266-399 ft.

4 Set DSX-1 equalization for 399-533 ft.

5 Set DSX-1 equalization for 533-666 ft.

6 Set CSU attenuation for LBO of 0dB.

7 Set CSU attenuation for LBO of -7.5dB.

8 Set CSU attenuation for LBO of -15dB.

9 Set CSU attenuation for LBO of -22.5dB.

9. Set groom DS1 loop request code detection to on or off with the following command:

set ds1 <n> loopdetect <on|off>

Example: set ds1 10 loopdetect on

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 703 704

Comentários a estes Manuais

Sem comentários

Carrier-access Access Navigator Manual do Utilizador Página 207

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Carrier-access Access Navigator