Carrier Access Network Device Axxius 800 Manual do Utilizador descarregar pdf (Página 265)

100

101

Axxius 800 - Release 2.2 5-165

CLI Commands

set

set (router-wan) trunk

Use the set (router-wan) trunk command to configure the trunk port or multilink group for a

specified WAN interface. If the trunk encapsulation is subsequently changed, this trunk

assignment is reset to 0.

Syntax: set {rtr_card-addr} {"wan-name"} trunk

[multilink-group] {number}

Example: set 1 "LosAngeles" trunk 3

The example will set the WAN interface named "LosAngeles" on the Router

card in slot 1 to be mapped to trunk 3.

{rtr_card-addr}

The slot number (1-8) that contains the Router card.

{"wan-name"}

The WAN interface to modify. The name must be enclosed in quotes.

[multilink-group]

This optional parameter, indicates that the number is the multilink group to use, else the

number is the trunk number to use.

{number} - Number of the trunk or multilink group to use, range is 1-24.

set (router-wan) up/down

Use the set (router-wan) up/down command to set the specified WAN interface up or down.

Syntax: set {rtr_card-addr} {"wan-name"} {down|up}

Example: set 1 "LosAngeles" up

The example will enable the WAN interface named "LosAngeles" on the Router

card in slot 1.

{rtr_card-addr}

The slot number (1-8) that contains the Router card.

{"wan-name"}

The WAN interface to modify. The name must be enclosed in quotes.

{down|up}

down Set the Router WAN to disabled.

up Set the Router WAN to enabled.

1 2 ... 260 261 262 263 264 265 266 267 268 269 270 ... 567 568

Comentários a estes Manuais

Sem comentários

Carrier Access Network Device Axxius 800 Manual do Utilizador Página 265

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Carrier Access Network Device Axxius 800